Consumables by ACROW

WING NUT 15mm

• The wing nut is used as a tie nut for the washer for timber and steel flanges. It is designed for installation/removal by hexagon wrench or only with a threadbar. If required the nut can be locked/released by hammer blow to the wings.
  

Specification:

WING NUT 20mm

• The wing nut is used as a tie nut for the washer for timber and steel flanges. It is designed for installation/removal by hexagon wrench or only with a threadbar. If required the nut can be locked/released by hammer blow to the wings.
  

Specification:

WASHER

• Washers are used in conjunction with wing nuts to take the loading from the 15 mm threadbar onto Slimlite 11 Soldiers.
  
• Also available for 20 mm threadbar. Capacity as Wing nut.
  

Specification:

PLASTIC TUBING

• Rigid plastic tubing facilitates clean removal of threadbar for re-use. Supplied in approx 3 m lengths.
• The tube should be cut 25 mm or 100 mm less than wall thickness to allow for plastic cones at either end.
  

PLASTIC CONES

• Plastic push-fit cones are used to seal the rigid plastic tubing at either end ensuring the correct wall thickness. Two types are available as shown.
  

STEEL PLASTIC CONE

• This plastic cone with a steel core can be used in the concreting of water-tight walls. The cones are mounted on the inside of the form, being secured on the outside by threadbar, washer and wingnut.
• The dimension of the formwork spacing is achieved by a "lost" internal tie.

Specification: